favorite
favorite
hide
unhide
flag

Posted

print

Bilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus

Bilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 1 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 2 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 3 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 4 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 5 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 6 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 7 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 8 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 9 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 10 thumbnailBilco D-50 Aluminum Roof Hatch - Equipment Access - (6) New Surplus 11 thumbnail
condition: new
make / manufacturer: BILCO
model name / number: D-50

more ads by this user

Bilco D-50 Aluminum Roof Hatch - Equipment Access - New Surplus (Qty 6)

- They will fit a 4’-10” x 8’-10” rough opening
(provides a convenient way to install or remove large pieces
of equipment from a building).

- They have a hinged toggle clamp that automatically locks when the hatch is closed.
(Note: Unit cannot be opened from underside while toggle clamps are engaged)

- This feature along with the curb attachment to the structural
has gotten a 78 PSF design rating for uplift and engineering,
so it meets the Florida Building Code minimum standards.

- This product may be installed on either a flat or sloping roof.
When installed on a slope, the hinge side must run parallel with the slope.
Slope must not exceed 30 degrees.

Specifications:
- Frame is 11 Gauge Aluminum w/Capflashing (Corners Full Welded)
- Pintle Hinge
- Gasket (all around the cover)
- Cover is 11 Gauge Aluminum
- Cover Liner is 18 Gauge Aluminum
- Spring Lift Mechanism
- Curb Insulation - 1" Fiberboard
- Two Point Latch Enclosure (Same mat'l as cover)
- Inside & Outside Handles w/Padlock Hasps
- Arm Guide Bracket
- Cover Insulation - 1" Fiberglass
- Hold Open Arm w/Red Vinyl Grip
- Neoprene Gasket
- Guide Arm (If required)
- BILCLIP Flashing System
- Lock Strike
- CL-500-PA & CL-500-PAA Exterior Toggle Clamps
(2 Req'd, 1 @ Each End)

Shop Finish:
Cover: Mill Finish
Frame: Mill Finish
Hardware: Non-Corrosive Materials
(Unless Otherwise Specified)

Overall Dimensions: 9'-5"L x 5'-5"W
Curb: 12" High
Weight: 462 lbs. Each

NOTE: IN STOCK, READY TO LOAD ONTO YOUR TRUCK!
Freight Rates Are Available (Need Zip Code)

post id: 7712862391

posted:

updated:

best of [?]

loading
reading
writing
saving
searching